Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 82)

Publication 1757-IN500A-EN-P - September 2002
3-16 ProcessLogix Server Installation Procedures
3. Click the 1784-PCIC(S) for ControlNet devices selection in the
Available Drivers list box and click Add New to call up the Add New
RSLinx Driver dialog box.
4. Click OK to accept the default name AB_PCIC-1 for the driver.
5. In the Configure 1784-PCIC window, enter the following:
a. Serial Number(hex): This value is read from the PCIC card and does
not change.
b. Network Address(dec): Change the default of 99 to:
• Non-redundant Server 24
• Redundant Server A 24
• Redundant Server B 23
6. Click OK start the PCIC driver.
7. In the Configure Drivers dialog box, you should see AB_PCIC-1 listed
in the Configured Drivers list with the status Running. If the
AB_PCIC-1 driver status is not Running, call Rockwell Automation
Technical Support. Refer to Rockwell Automation Technical Support in
the Preface.
8. Click Close to close the Configure Drivers dialog box.
9. Close RSLinx.
IMPORTANT The driver name MUST be AB_PCIC-1