Rockwell Automation 1757-SWKIT5000 ProcessLogix R500.1 Installation and Upgrade Guide - Manual (Page 160)

Publication 1757-IN500A-EN-P - September 2002
6-4 Additional Redundant Server Procedures
Changing TCP/IP address on a Secondary Server (SERVERB)
If you need to change the TCP/IP address on SERVERB to agree with Hosts
file entries, do the following:
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the Network and Dial-up Connections icon.
3. Right-click the Local Area Connection icon and select Properties.
4. Select TCP/IP Protocol and click Properties.
5. Enter the TCP/IP address and appropriate Subset mask.
Changing the ProcessLogix License
If the license for redundant Servers has been installed, skip to Setting up
Primary Server (SERVERA) on page 6-6.
TIP
Networked PCs must have unique addresses. For example,
if the address for SERVERA is 192.168.0.1, you could
change the SERVERB address to 192.168.0.2.