Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 117)

Starting Up the Drive Using the LCD OIM 10-1
C
HAPTER
10
Starting Up the Drive
Using the LCD OIM
For standard applications, the Start-Up routines on the LCD OIM
enable you to configure the most commonly used parameters
through a series of steps. This helps you set up the drive as quickly
as possible.
For advanced applications, you may need to adjust additional
parameters in the parameter list using either the LCD OIM or VS
Utilities software.
10.1 Preparing for Start-Up
Before performing Start-Up, you must:
• be qualified to configure the drive and be familiar with the
operation of AC drives.
• be familiar with the operation of the LCD OIM.
• have completed all hardware installation as described in chapters
3 through 8 of this manual.
• properly connect the drive to the motor.
!
ATTENTION: Only qualified electrical personnel
familiar with the construction and operation of this
equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and
understand this chapter in its entirety before
proceeding. Failure to observe this precaution could
result in severe bodily injury or loss of life.
ATTENTION: Incorrect values for some of the
parameters in the Start-Up routines can cause the
drive to operate improperly. Verify that the values of
these parameters are appropriate for your
application. Failure to observe this precaution could
result in bodily injury.