Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 243)

Troubleshooting the Drive 13-11
13.4.3 Fault Descriptions and Corrective Actions
Table 13.6 describes drive faults and corrective actions. It also
indicates if the fault is:
➀ Auto-resettable
➁ Non-resettable
➂ User-configurable
Table 13.6 – Fault Descriptions and Corrective Actions
Fault No
.
Ty
p
e
Description Action
Analog In
Loss 29 An analog input is
configured to fault on
signal loss. A signal loss
has occurred.
Configure with Anlg In
1, 2 Loss (324, 327).
1. Check parameters.
2. Check for broken/loose
connections at inputs.
Anlg Cal
Chksum 108 The checksum read
from the analog
calibration data does
not match the checksum
calculated. Replace drive.
Auto Rstrt
Tries 33 Drive unsuccessfully
attempted to reset a
fault and resume
running for the
programmed number of
Auto Rstrt Tries (174).
Enable/disable with
Fault Config 1 (238).
Correct the cause of the
fault and manually clear.
AutoTune
Aborted 80 The autotune procedure
was canceled by the
user. Restart procedure.
DB
Resistance 69 Resistance of the
internal DB resistor is
out of range. Replace resistor.