Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 204)

12-74 SP600 AC Drive User Manual
Displays the present frequency reference scaled as a DPI reference
for peer-to-peer communications. The value shown is the value after
the accel/decel ramp but prior to any corrections supplied by slip
comp, PI, etc.
Disables manual requests at the port corresponding to bit number.
Example of manual mode selection source:
If:
• Bit 0 = 0 (Terminal block disabled)
• Bit 1 = 1 (Local OIM enabled)
Then manual mode selection can be activated from the OIM but not
the I/O terminals.
273 Drive Ramp Rslt
Range: 0 to 32767 [1]
Default: Read Only
Access: 2 Path: Communication>Comm Control
See also:
286 Manual Mask
Range: See figure 12.44
Default: See figure 12.44
Access: 2 Path: Communication>Masks & Owners
See also:
Figure 12.44 – Manual Mask (286)
1 1 x x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Enabled
0 =Disabled
x =Reserved
Bit #
Factory Default Bit Values
Local OIM DPI P
or
t 2
Nibble 1 Nibble 2 Nibble 3 Nibble 4
x x 1
Ter
minal Blk
Reser
ved
Netw
or
k
1 1
DPI P
or
t 3
Reser
ved
x x x