Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 195)

Parameter Descriptions 12-65
Displays the source that initiated the most recent stop command. It
will be cleared (set to 0) during the next start sequence.
Displays the current state of the digital inputs on the terminal block.
215 Last Stop Source
Range: 0 = Pwr Removed
1 = Local OIM
2 = DPI Port 2
3 = DPI Port 3
4 = Reserved
5 = Network
6 = Reserved
7 = Digital In
8 = Fault
9 = Not Enabled
10 = Sleep
11 = Jog
Default: Read Only
Access: 2 Path: Utility>Diagnostics
See also:
216 Dig In Status
Range: See figure12.35
Default: Read Only
Access: 2 Path: Utility>Diagnostics
Inputs & Outputs>Digital Inputs
See also: 361-366
Figure 12.35 – Dig In Status (216)
0 0 0 0 0 0 x x x x x x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Input Present
0 =Input Not Present
x =Reserved
Bit #
Digital In1 Digital In2 Digital In3 Digital In4 Digital In5 Digital In6
Nibble 1 Nibble 2 Nibble 3 Nibble 4
Function Terminal #
Digital In1 1
Digital In2 2
Digital In3 3
Digital In4 4
Digital In5 5
Digital In6 6