Rockwell Automation SP600 AC Drive User Manual Version 1.0 User Manual
Page 85
Installing Control Wiring
7-3
Table 7.1 – Wiring Signal and Control I/O to the Terminal Block
No.
Signal
Factory
Default
Description
Re
la
te
d
Pa
ra
m
.
1
Digital In1 Sel
Stop – CF
(CF = Clear
Fault)
11.2 mA @ 24V DC
19.2V minimum on state
3.2V maximum off state
Important: Use only 24V DC, not
suitable for 115V AC circuitry.
Inputs can be wired as sink or source.
361 -
366
2
Digital In2 Sel
Start
3
Digital In3 Sel
Auto/Man
4
Digital In4 Sel
Speed Sel 1
5
Digital In5 Sel
Speed Sel 2
6
Digital In6 Sel
Speed Sel 3
7
24V Common
–
Drive supplied power for Digital In1-6
inputs.
150mA maximum load.
8
Digital In Common
–
9
+24V DC
–
10
+10V Pot Reference
–
2 k ohm minimum load.
11
Digital Out 1 – N.O.
1
NOT Fault
Max Resistive
Load
250 VAC/30 VDC
50 VAC / 60 Watts
Minimum DC
Load
10 µA, 10 mV DC
Max Inductive
Load
250 VAC/30 DC
25 VAC / 30 Watts
380 -
387
12
Digital Out 1 Common
1
13
Digital Out 1 - N.C.
Fault
14
Analog In 1 (– Volts)
(2)
Voltage –
Reads value
at 14 & 15
Non-isolated, 0 to +10V, 10 bit,
100k ohm input impedance.
3
320 -
327
15
Analog In 1 (+ Volts)
16
Analog In 1 (– Current)
Non-isolated, 4-20mA, 10 bit,
100 ohm input impedance.
3
17
Analog In 1 (+ Current)
18
Analog In 2 (– Volts)
(2)
Voltage –
Reads value
at 18 & 19
Isolated, bipolar, differential, 0 to
+10V unipolar (10 bit) or ±10V bipolar
(10 bit & sign), 100k ohm input
impedance.
4
19
Analog In 2 (+ Volts)
20
Analog In 2 (– Current)
Isolated, 4-20mA, 10 bit & sign,
100 ohm input impedance.
(4)
21
Analog In 2 (+ Current)
22
Analog Out (– Volts)
10V Pot Common
(2)
Output Freq
0 to +10V, 10 bit, 10k ohm (2k ohm
minimum) load.
Referenced to chassis ground.
Common if internal 10V supply
(terminal 10) is used.
341 -
344
23
Analog Out (+ Volts)
14
26
13
1