Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 71)

Installing Power Wiring 6-1
C
HAPTER
6
Installing Power Wiring
This chapter provides instructions on output wiring to the motor and
installing AC input power wiring. Refer to figure 6.5 for a description
of the power terminal block.
6.1 Removing and Replacing the Cover
6.1.1 Removing and Replacing the Cover on NEMA 1
Drives
Removing the Cover
Follow these steps to remove the drive cover on NEMA 1 drives:
Step 1. Loosen the cover screw (refer to figure 6.1).
Step 2. Lift the cover straight off the drive to avoid damaging the
connector pins.
!
ATTENTION: The user is responsible for conforming with all
applicable local and national codes. Failure to observe this
precaution could result in damage to, or destruction of, the
equipment.
!
ATTENTION: DC bus capacitors retain hazardous voltages
after input power has been removed. After disconnecting input
power, wait five minutes for the DC bus capacitors to discharge
and then check the voltage with a voltmeter to ensure the DC
bus capacitors are discharged before touching any internal
components. Failure to observe this precaution could result in
severe bodily injury or loss of life.