Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 39)

Mounting the Drive 3-1
C
HAPTER
3
Mounting the Drive
This chapter provides information that must be considered when
planning a SP600 AC drive installation and provides drive mounting
information. Installation site requirements, drive requirements, and
wiring requirements are presented.
!
ATTENTION: Only qualified electrical personnel familiar with
the construction and operation of this equipment and the
hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other
applicable manuals in their entirety before proceeding. Failure
to observe this precaution could result in severe bodily injury
or loss of life.
ATTENTION: Use of power correction capacitors on the
output of the drive can result in erratic operation of the motor,
nuisance tripping, and/or permanent damage to the drive.
Remove power correction capacitors before proceeding.
Failure to observe this precaution could result in damage to,
or destruction of, the equipment.
ATTENTION: The user is responsible for conforming with all
applicable local, national, and international codes. Failure to
observe this precaution could result in damage to, or
destruction of, the equipment.
ATTENTION: Do not submerge NEMA 4X/12 drives in water.
Use a waterproof cable gland for the cable lead-in section.
After wiring is complete, mount the front cover and bottom
cover carefully to avoid damaging the gasket. The front cover
mounting screws are made of stainless steel. Replacement
screws must be stainless steel and of the same length. Failure
to observe this precaution could result in damage to, or
destruction of the equipment.