Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 12)

X SP600 AC Drive User Manual
Table 12.5 – Speed Select Inputs ...........................................................12-88
Table 12.6 – Default Values for Parameters 361-366.............................12-88
Table 12.7 – Drive Response to Jog Forward and Jog Reverse Inputs..12-90
Table 12.8 – Effect of Speed Select Input State on Selected Reference12-92
Table 12.9 – Dynamic User Mode...........................................................12-94
Table 13.1 – Ready LED Status Definitions..............................................13-3
Table 13.2 – Types of Alarms ...................................................................13-4
Table 13.3 – Alarm Descriptions ...............................................................13-5
Table 13.4 – Alarm Names Cross-Referenced by Alarm Numbers13-7
Table 13.5 – Fault Types ..........................................................................13-8
Table 13.6 – Fault Descriptions and Corrective Actions .........................13-11
Table 13.7 – Fault Names Cross-Referenced by Fault Number .............13-17
Table 13.8 – Test Point Codes and Functions ........................................13-17
Table 13.9 – Drive Does Not Start From Start, Run, or Jog Inputs Wired
to the Terminal Block .........................................................13-18
Table 13.10 – Drive Does Not Start or Jog From OIM ............................13-19
Table 13.11 – Drive Does Not Respond to Changes
in Speed Command .........................................................13-20
Table 13.12 – Drive Does Not Operate in Manual Mode ........................13-21
Table 13.13 – Motor and/or Drive Will Not Accelerate
to Commanded Speed .....................................................13-21
Table 13.14 – Motor Operation is Unstable ............................................13-21
Table 13.15 – Drive Will Not Reverse Motor Direction............................13-22
Table 13.16 – Stopping the Drive Results in a Decel Inhibit Fault ..........13-22
Table 13.17 – OIM Cables ......................................................................13-23
Table 13.18 – NEMA 4 Covers ...............................................................13-23