Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 296)

Index-6 SP600 AC Drive User Manual
OIM , 9-17
stopping, user-initiated , 7-2
T
TB Man Ref Hi (97) , 12-25
TB Man Ref Lo (98) , 12-26
TB Man Ref Sel (96) , 12-25
technical assistance , 1-1
terminal block, I/O
location , 5-2
specifications , 4-5
terminal block, power
location , 5-2
specifications , 4-3
test point codes and functions , 13-17
Testpoint 1 Data (235) , 12-70
Testpoint 1 Sel (234) , 12-70
Testpoint 2 Data (237) , 12-70
Testpoint 2 Sel (236) , 12-70
thermal overload protection , 2-11
thermal overload, motor , 12-9
three-wire start/stop control , 10-6
time stamp, fault queue , 13-9
Torque Current (4) , 12-5
Torque Perf Mode (53) , 12-12
torques, power terminal , 6-5
Trim Hi (119) , 12-28
Trim In Select (117) , 12-27
Trim Lo (120) , 12-28
Trim Out Select (118) , 12-28
troubleshooting
common symptoms and corrective
actions , 13-18
using the LCD OIM , 13-23
two-wire start/stop control , 10-6
U
unbalanced distribution systems , 3-3
ungrounded distribution systems , 3-3
user sets
about , 2-13
loading and saving using LCD
OIM , 9-8
V
voltage class , 2-17
Voltage Class (202) , 12-58
VS Utilities , 2-24
connecting to NEMA 4 drives , 2-23 ,
2-24
W
watts loss rating, verifying , 3-15
watts loss ratings , 2-4 , 2-6
wire routing , 5-1 to 5-2
wiring
control and signal , 4-5
motor lead lenghts , A-10
motor lead lengths , 4-5
power , 4-1 to 4-3
three-wire start/stop control , 10-6
two-wire start/stop control , 10-6
wiring diagram
default drive configuration , 7-9
I/O , 7-7