Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 68)

5-2 SP600 AC Drive User Manual
Important: Use the plugs supplied with IP66 (NEMA Type 4X/12)
rated drives to seal unused holes in the cable entry
area.
!
ATTENTION: Unused wires in conduit must be grounded at
both ends to avoid a possible shock hazard caused by induced
voltages. Also, if a drive sharing a conduit is being serviced or
installed, all drives using this conduit should be disabled to
eliminate the possible shock hazard from cross-coupled motor
leads. Failure to observe these precautions could result in
bodily injury.
Power Terminal Block
SHLD Terminal
Suggested entry for incoming line wiring
Suggested entry for motor wiring
I/O Terminal Block (Signal and Control)
Suggested entry for communication wiring
➐ Suggested entry for I/O and control wiring
➑
Cable Entry Plate
Figure 5.1 – Typical Wire Routing and Terminal Block Locations (5 HP Drive Shown)
➋
➌
➌
➌
❶
➍
➍
➍
➎
➏
➐
➑
➏
➏
➐
➐
IP20 (NEMA Type 1)
IP66
(NEMA Type 4X/12)