Enterasys Networks 1G58x-09 - Manual (Page 351)

VLAN Configuration Command Set
Creating and Naming Static VLANs
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-9
7.3.2 Creating and Naming Static VLANs
Purpose
To create a new static VLAN, or enable/disable the new or other existing static VLANs.
Commands
The commands needed to establish new or remove VLANs are listed below and described in the
associated section as shown.
• set vlan ( Section 7.3.2.1 )
• set vlan name ( Section 7.3.2.2 )
• clear vlan ( Section 7.3.2.3 )
• clear vlan name ( Section 7.3.2.4 )
7.3.2.1 set vlan
Use this command to create a new static IEEE 802.1Q VLAN, or to enable or disable an existing
VLAN. When a new VLAN is created, it is added to the list of VLANs that the device will
recognize. Once a VLAN is created, you can assign it a name using the set vlan name command
described in
Section 7.3.2.2 .
set vlan {create | enable | disable} vlan-list
Syntax Description
Command Defaults
None.
NOTE: Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device
assumes that the Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 2 and 4094. The VLAN IDs of 0, 1,
and 4095 and higher may not be used for user-defined VLANs.
create | enable |
disable Creates, enables or disables a VLAN.
vlan-list Specifies the number of the VLAN(s) to be created, enabled
or disabled.