Enterasys Networks 1G58x-09 - Manual (Page 429)

Port Priority and Classification Configuration Commands
Configuring Quality of Service (QoS)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-11
9.3.3 Configuring Quality of Service (QoS)
Purpose
To configure one or more ports with the following Layer 2 switching features:
• Four priority queues on each port.
• Programmable scheduling per transmit (Tx) port according to fixed priority, weighted
round-robin (in percentage of traffic per queue), or hybrid algorithm.
Command Descriptions
The commands to configure the Quality of Service are listed below and described in the associated
section.
• show port qos ( Section 9.3.3.1 )
• set port qos sp ( Section 9.3.3.2 )
• set port qos wrr ( Section 9.3.3.3 )
• set port qos hybrid ( Section 9.3.3.4 )
9.3.3.1 show port qos
Use this command to display Quality of Service information, including the current QoS algorithm
and associated queue settings, for one or more ports.
show port qos [port-string]
Syntax Description
Command Defaults
If the port-string is not specified, the QoS settings for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
port-string (Optional) Display QoS settings for specific port(s). For a
detailed description of possible port-string values, refer
to
Section 4.1.2 .