Yaskawa iQpump Controller User Manual User Manual
Page 55
Advertising
2.3 Control Wiring
YASKAWA TM.iQp.06 iQpump Controller User Manual
55
■
Feedback Device (3-Wire)
Connection of a 3-Wire 0 ~ 10 Vdc Feedback Device (H3-08 = 0)
In order to use a 4 ~ 20 mA feedback device, parameter H3-08 Terminal A2 Signal has to be programmed to 2.
Note: In order to use a 0 ~ 10V feedback device parameter for terminal A2, the parameter H3-08 Terminal A2 Signal has to be
programmed to 0 and DIP Switch S1-2 has to be set to OFF for the iQpump to accept a 0 ~ 10 Vdc signal.
Figure 2.12 Feedback Device (3-Wire) Connection
Advertising