Yaskawa iQpump Controller User Manual - Manual (Page 68)

3.6 Programming Menu (-ADV-)
68 YASKAWA TM.iQp.06 iQpump Controller User Manual
3.6 Programming Menu (-ADV-)
This menu is used to set / read every parameter in the iQpump drive. Follow the key operations below ( Figure 3.7 ) to access the
Programming Menu.
Figure 3.7 Programming Menu Access Procedure
Use , , and keys to scroll through the Programming Parameter Group List. For complete parameter listing Refer to
Parameters on page 165 .
Table 3.12 Programming Parameter Group List
◆ Modified Constants Menu (-VERIFY-)
This menu is used to set / read the parameters that have been modified from their original factory default settings. Follow the key
operations below ( Figure 3.8 ) to access the Modified Constants Parameter Menu.
Figure 3.8 Modified Constants Menu Access Procedure
Note: If there are not any parameters that have been modified from their original factory default settings, then the display will
state “None Modified.” Otherwise, use the “increase” and “decrease” keys to scroll through the “Modified Constants”
list.
Parameter Group Functions Parameter Group Functions
A1 Initialization L1 Motor Overload
b1 Sequence L2 PwrLoss Ridethru
b2 DC Braking L3 Stall Prevention
b3 Speed Search L4 Ref Detection
b4 Delay Timers L5 Fault Restart
b5 PI Control L6 Torque Detection
b8 Energy Saving L8 Hdwe Protection
C1 Acce l /Decel n1 Hunting Prev
C2 S-Curve Acc / Dec n3 High Slip
C4 Torque Comp o1 Monitor Select
C6 Carrier Freq o2 Key Selections
d1 Preset Reference o3 COPY Function
d2 Reference Limits P1 Pump Basic
d3 Jump Frequencies P2 Pump Protection
E1 V/F Pattern P3 Pump Multiplex
E2 Motor Setup P4 Pump Advanced
F6 Com OPT Setup P5 Hand Mode
H1 Digital Inputs P6 Flow Meter Setup
H2 Digital Outputs P7 Anti-Jam / De-Scale
H3 Analog Inputs P8 Pressure and Level Control
H4 Analog Outputs P9 Network Options
H5 Serial Com Setup
-ADV-
** Main Menu **
- - - - - - - - - - - - - -
Programming
-ADV-
Initialization
- - - - - - - - - - - - - - - - - - - -
A1 -00= 0
Select Language x3
-VERIFY-
** Main Menu **
- - - - - - - - - - - - - -
Modified Consts
See Note 1
x4
See Note 1