Hitachi GR2000 Series - Manual (Page 124)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
5-24 GR2K-GA-0015
Ver. 07-02
5.4.2.4 PIM-SM BSR information
Enter the show ip pim bsr command from the terminal and confirm that the BSR
address is indicated. If you see ’---" indication, there is a possibility that the BSR may
not advertise the Bootstrap message, or the BSR may not exist. Please investigate the
BSR. Notice that BSR is not used in PIM-SSM.
Figure 5-44 Result of show ip pim bsr Command
5.4.2.5 PIM-SM rendezvous point information
Enter the ip show pim rendezvous-point mapping command from the terminal and
confirm that the C-RP Address is indicated against the applicable multicast group
address. If there is no indication, there is a possibility that the BSR may not
advertise the Bootstrap message, or the rendezvous point or BSR may not exist.
Please investigate the rendezvous point and BSR. Notice that the rendezvous point is
not used in PIM-SSM.
Figure 5-45 Result of ip show pim rendezvous-point mapping Command
5.4.2.6 PIM-SM routing information
Enter the show ip mroute command from the terminal and confirm that the route to
the subject destination address exists. If no (S.G) entry exists, confirm that the (*, G)
entry exists. If no (*, G) exists, and if the in-coming, downstream is not correct,
investigate the neighbor router. (*,G) is not used (does not exist) in PIM-SSM.
> show ip pim bsr
Status: Not Candidate Bootstrap Router
BSR Address:192.10.10.10
Priority:100,Hash Mask length:30
Uptime:03:00
Bootstrap Timeout:130 seconds
>
> show ip pim rendezvous-point mapping
Status: Not Candidate Rendezvous Point
Total: 2 routes, 2 group, 1 RPs
Group/masklen C-RP Address pri Uptime Expires
224.100.100.0/24 192.1.1.1 100 02:00 02:30
224.100.200.0/24 192.1.1.1 100 02:00 02:30
>