Hitachi GR2000 Series - Manual (Page 55)

Before Operation Start
GR2K-GA-0015 1-5
Ver. 07-02
1.2 Preparation for operation of the router
1.2.1 Console
The console is required as an operation terminal during initial installation of the
router. It is the terminal connected to RS-232C. A general communication terminal
and communication software can be used on the console.
1.2.1.1 Communication software
The communication software used on the console is partially described below.
Hyper-terminal supplied for Microsoft Windows 95, Windows 98, Windows 2000, and
Windows NT.
Terminal supplied for Microsoft Windows 3.1.
Tera Term Pro(Version 2.3)
1.2.1.2 Confirmation of set values of communication software
Confirm that the standard VT-100 set value below (default set value of the router) is
set in the communication software for the console to communicate with the router.
Communication speed: 9600 bps
Data length: 8 bits
Parity bit: None
Stop bit: 1
Flow control: None
Change the communication speed setting of the router using a configuration
definition command (CLI Type 1) router to set communications speeds (1200, 2400,
4800, and 19200 bps) other than 9600 bps to the communication speed. The setting
is saved, however, after the user logs out of the console once.
1.2.1.3 Precautions during use of communication software
The communication software described in (1), should be subject to the precautions
below.
(a) Hyper-terminal
The communication speed does not actually change even if it is changed during
connection. However, the value on the status bar display is the value obtained
after communication speed is changed. Disconnect and connect from the tool bar
to change the communication speed.
(b) Terminal supplied for Windows 3.1
The relay function of a command cannot be used by simultaneously pressing the
[Ctrl] and [C] keys. The operation based on the combination of [ESC] and [Ctrl]
keys and of a function key and special symbol generally varies depending on the
communication software.