Hitachi GR2000 Series - Manual (Page 265)

Maintenance Procedure
GR2K-GA-0015 8-3
Ver. 07-02
8.2 Transmission of Maintenance Information
This section describes how to use commands for transmitting error log files and
dump information files, which have been automatically created in the event of a
failure on GR2000 in operation, to the device management terminal. The three
methods use the
ftp , zmodem and show tech-support commands. Table 8-2 shows how
such maintenance information is transmitted.
Table 8-2 Transmission of Maintenance Information
No. Category Directory and File name
1 Dump information file created
when router reboots /primaryMC/var/dump/rmdump
2 Dump information file for RP
and NIF /primaryMC/var/dump/rp**.*** ... Standard RP dump
/secondaryMC/var/dump/rp**el.*** ... Extended RP dump (Only
when extended RP dump is specified)
/primaryMC/var/dump/nif**.*** ... NIF dump
(**: slot number, ***: sequence number or “cmd”)
3 Log information Stored under the name as follows from the specified directory
(see Figure 8-2):
•
Operation log: log.txt
• Individual log: log_ref.txt
4 Configuration information file /config/router.cnf
5 Impediment avoiding
information /primaryMC/var/core/*.core
*
Note: When the files indicated in the first, second and fifth entries are transferred using the ftp
command, transfer such files in binary mode.
For the function and the method of the extended RP dump, see “dump rp” in GR2000
Operations Commands, Vol. 1. When you specify the extended RP dump, two dump files—
one for the standard RP dump and the other for the extended RP dump—will be created.