Hitachi GR2000 Series - Manual (Page 65)

Command operation
GR2K-GA-0015 3-3
Ver. 07-02
3.2 Operation Using the Command Line Interface (CLI)
3.2.1 Login
Enter your user name and password. The UNIX shell command prompt appears as
illustrated in Figure 3-1. If the user name and password are correctly authenticated,
a UNIX shell command prompt is displayed. If they are not correctly authenticated, a
"Login incorrect" message is displayed.
Figure 3-1 Login Window
3.2.2 CLI Actuation
To operate the CLI after log-in, actuate cli command using the UNIX shell command
prompt. The CLI actuation screen is shown in Figure 3-2
Figure 3-2 CLI Actuation
3.2.3 CLI Termination
To return to the UNIX shell command prompt after finishing the CLI operation,
execute a
quit command. To finish the operation using CLI and log out, execute a
logout or exit command. If logged in again by using the same user account as before,
the UNIX shell command prompt will not display, but the CLI prompt will. The
execution screens are shown in Figure 3-3, Figure 3-4, and Figure 3-5.
Figure 3-3 UNIX Shell Prompt Display After Finishing the CLI
Figure 3-4 Logout From the CLI Prompt
login: operator
Password: *******
All Rights Reserved,Copyright(C)1999,2002,Hitachi, Ltd.
*** Welcome to the Router ***
command:
Not displayed when the password is not defined to
the system. The input characters are masked.
UNIX shell command prompt
CLI type 1
command: cli
>
CLI type2
command: cli2
>
command: cli
>
> logout
login: