Hitachi GR2000 Series - Manual (Page 142)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
5-42 GR2K-GA-0015
Ver. 07-02
5.7.2.3 Transmission source route information
Execute a show ipv6 rpf command and confirm the transmission source route
information.
Figure 5-77 Result of show ipv6 rpf Command
5.7.2.4 PIM-SM BSR information
Enter the show ipv6 pim bsr command from the terminal and confirm that the BSR
address is indicated. If you see ’---" indication, there is a possibility that the BSR may
not advertise the Bootstrap message, or the BSR may not exist. Please investigate the
BSR. Notice that BSR is not used in PIM-SSM.
Figure 5-78 Result of show ipv6 pim bsr Command
5.7.2.5 PIM-SM rendezvous point information
Enter the show ipv6 pim bsr command from the terminal and confirm that the C-RP
Address is indicated against the applicable IPv6 multicast group address. If there is
no indication, there is a possibility that the BSR may not advertise the Bootstrap
message, or the rendezvous point or BSR may not exist. Please investigate the
rendezvous point and BSR. Notice that the rendezvous point is not used in PIM-SSM.
Figure 5-79 Result of show ipv6 pim rp mapping Command
PIM
Router
PIM
Router
Own
Router
Server 1
IP multicast data from Server 1
> show ipv6 pim rpf
RPF Information for ? (3ffe:ffff::1324):
If multi1 NextHop fe80::1
> show ipv6 pim bsr
Status: Not Candidate Bootstrap Router
BSR Address:3ffe:ffff:1234::5
Priority:100,Hash Mask length:30
Uptime:03:00
Bootstrap Timeout:130 seconds
>
> show ipv6 pim rp mapping brief
Status: Not Candidate Rendezvous Point
Total: 2 routes, 2 group, 1 RPs
Group/masklen C-RP Address
ff0f::5/128 3ffe:ffff::200:87ff:fe19:9ba9
ff0f::9/128 3ffe:ffff::1592
>