Hitachi GR2000 Series - Manual (Page 296)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
8-34 GR2K-GA-0015
Ver. 07-02
(1) Assurance on RP
[Example]
To assure the status of each RP, enter show router command from the device
management terminal as follows:
> show router [CR]
The result will appear as in Figure 8-35. This example assumes that the RP No. 1 has
been added or swapped and hence the operator wanted to see if the new RP1 is
working.
The subject RP is operating normally (in this example, “RP1: active”)
If the expected result does not appear, ensure the following:
When the RP does not operate normally (“RP1: active” is not given):
1. Is the RP installed?
2. Is there any loose contact on the RP or the corresponding NIF?
3. Is startup of the subject router complete?
4. Is startup of the subject RP complete?
Figure 8-35 Result of information Command on RP
(2) Assurance on Ethernet/Gigabit Ethernet Line
[Example]
To assure the Ethernet or Gigabit Ethernet line, enter the show nif (LAN) command
from the device management terminal as follows:
> show nif 2 [CR]
The result will appear as Figure 8-36, which assumes that the line No. 0 in NIF No. 2
has been defined as AutoNegotiate and connected to the hub with AutoNegotiate
setting. In this example the line is enabled because of the following:
The subject NIF is operating normally (in this example, “NIF2: active”).
The subject line is operating normally (in this example, “Line0: active up”).
The line type meets the device (in this example, “100BASE-TX (auto), full”).
> show router
:
rp1 :unused
rp1 :active RP-A
lamp : LED = green
memory : size = 32,768KB(32MB),12,800KB(12.5MB) used
Fixed area used = 6,656KB(6.0MB)
WAN used = 4,608KB(4.5MB)
Ether used = 512KB(0.5MB)
ATM used = 0KB(0.0MB)
IP(unicast) used = 1,024KB(1.0MB)
IP(multicast) used = 0KB(0.0MB)
cipher/compress board:unused
statistics/carge board:unused
rp2 :initialize
rp3 :closed
rp4 :unused
>