Enabled -86 – Hitachi GR2000 Series User Manual
Page 252
Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
7-86
GR2K-GA-0015
Ver. 07-02
7.11.6
There is no IPv4 unicast routing information inside MPLS network
Eliminate the fault in accordance with Section 7.6, “Communication failure in IPv4
unicast routing”.
7.11.7
Communication cannot be maintained inside MPLS network or MPLS
communication cannot be enabled
7.11.7.1
Check IPv4 unicast routing information inside MPLS network
Check IPv4 unicast routing information inside the MPLS network between the sites
that cannot communicate, in accordance with Subsection 5.8.1, “Confirming the
IPv4 unicast routing information in an MPLS network.”.
When there is IPv4 unicast routing information
Go to item Subsection 7.11.7.2, “Check label.”.
3
When the VC label indication of both
local and remote is "-"
Check to see if the local and remote units match each other in the
configuration definition information (VCID, targeted peer).
4
When the tunnel label indication is "-"
Investigate the cause in accordance with Subsection 7.11.8.2.
5
When all label indications are shown
Check to see if the local and remote units match each other in the
parameters of the configuration definition information.
Note:
If the displayed data are compound, execute the check item on each one of them.
Table 7-36 Displayed contents of labels and check items
Item
No.
Confirmation contents and command
Remedy