Lenze 9400 - Manual (Page 42)

4 Drive interface
4.2 Device commands
42
Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2 Device commands
In the following subchapters the device commands of the controller are described, which are
provided in C00002 and which can be executed by means of the »Engineer« or alternatively with the
keypad when an online connection has been established.
Activating frequently required device commands via the toolbar
The simplest way to execute the frequently required device commands is directly via the Toolbar of
»Engineer« when an online connection has been established.

Note!
Before switching off the supply voltage after a device command has been executed,
check the successful execution of the device command via the status display in C00003 !
The meaning of the status display in C00003 can be obtained from the subchapter for
the corresponding device command.
Icon Function
Enable controller
Inhibit controller
Start application
Inhibit controller and Stop application

Note!
Device commands that can be executed via the Toolbar of the »Engineer« always affect
the element currently selected in the Project view including all subelements!
• If no controller but a system module is selected in the Project view, the corresponding
device command will be activated in all lower-level controllers having an online
connection with the »Engineer«.
Before the desired action is carried out, a confirmation prompt appears first, asking
whether the action is really to be carried out.