Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 124)

7-12 Setting Up the Input/Output
3. Set Pulse In Offset (parameter 122) to 0.
4. Create a link from Speed Ref 1 (parameter 29) to Pulse In Value
(parameter 123).
Configuring the L Option I/O
The L Option input modes configure the L Option inputs. Chapter 5,
Using the L Option, describes the input modes The modes let you set
up the input to meet the requirements of your application. L Option
Mode (parameter 116) sets the mode and takes effect on a power
cycle or reset.
Accel Time 1 (parameter 42) and Accel Time 2 (parameter 43) and
Decel Time 1 (parameter 44) and Decel Time 2 (parameter 45) are
selected by modes 4, 11, and 14. Otherwise, the acceleration/
deceleration times follow Accel Time 1 and Decel Time 1.
Configuring the Manually Operated Potentiometer (MOP)
Function
The L Option I/O, modes 5, 9, and 15, control the Manually Operated
Potentiometer (MOP) function. The MOP up and MOP down,
increment and decrement MOP Value (parameter118) based on MOP
Increment (parameter 117), which is in rpm per second. To control
speed, you need to link MOP Value to a speed reference.
file: Interface/Comm
group: Digital Config
The stop type available in modes 3, 13, and 16 only affects the
L Option stop input. Two-wire run forward and run reverse use Stop
Type 1 when the circuit is opened. SCANport devices use Stop
Type 1. The stop types are set up in Logic Options (parameter 17).
file: Control
group: Accel/Decel
If the L Option mode is not 1, the L Option speed reference takes
ownership of the speed reference. To let other devices control speed
reference, disable the L Option speed reference with Dir/Ref Mask
(parameter 124) for modes 4 – 7, 10, 11, 14 – 25, or set Speed Ref 1,
2, and 3 – 7 for modes 2, 3, 8, 9, 12, and 13. If you select modes 19,
20, or 22, the L Option board takes precedence over Spd/Trq Mode
Sel (parameter 68).
file: Interface/Comm
group: Digital Config