1 and figure, 1 and, Three wire – Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX User Manual
Page 88
5-6
Using the L Option
Figure 5.1
L Option Mode Selection and Typical TB3 Connections
1 See Speed Select table.
2 Drive must be stopped to take Local Control. Control by all other adapters is disabled (except Stop).
3 These inputs must be present before drive will start.
4 For Common Bus, this becomes Precharge Enable.
5 Bit 11 of Logic Options (parameter 17) must be 0 for reverse direction control.
6 For soft faults only. You need to recycle power to the drive or reset to clear hard faults. For hard faults, refer to the Troubleshooting chapter.
7 To configure the stop type, refer to Logic Options (parameter 17). Note: This only affects the L Option stop. For modes that do not have Stop
Type, stop commands follow Stop 1 in Logic Options.
8 This input must be present before the fault can be cleared and the drive will start. This can be disabled through Fault Select 2 (parameter 22)
and Warning Select 2 (parameter 23).
9 Latched (momentary) starts require a stop to stop the drive.
10 In mode 5, the MOP value is not reset to 0 when you stop. In mode 27, the MOP value is reset when you stop.
19
20
21
22
23
24
25
26
27
28
29
30
Status
Not Stop , Clear Fault
Common
Status
Status
Status
Common
Status
Status
Status
Common
Enable
19
20
21
22
23
24
25
26
27
28
29
30
Start
Not Stop , Clear Fault
Common
Rev/Fwd
Not Ext Fault
Common
Speed Select 2
Speed Select 1
Common
Jog
Stop
Type
2nd/1st
Accel
Digital
Pot Up
Jog
Speed
Select 3
Speed
Select 3
2nd/1st
Decel
Digital
Pot Dn
Local
Control
Proc Trim Flux En
Ramp
Reset
2
3
4
5
6
17
18
Mode
Digital
Pot Up
Digital
Pot Dn
27
Three Wire
1
2
6
4
5
7
9
10
3
8
,