Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 390)

C-14 Using the Human Interface Module (HIM)
To remove the HIM, you need to:
1. Either remove the power or clear the port bit, which corresponds
to the port the HIM is attached to, in SP Enable Mask
(parameter 124) or Fault Select 1 (parameter 20) to prevent the
drive from faulting.
2. Remove the front cover of the drive.
3. Slide the module down out of its cradle.
To use the module from anywhere up to 10 meters (33 feet) from your
drive, you need to:
1. Connect the appropriate cable between the HIM and the
communications port (adapter 2, 3, 4, or 5) or adapter 1 (the HIM
cradle).
2. Set SP Enable Mask to enable the port that you plugged the HIM
into and/or Fault Select 1 (parameter 20).
To replace the module, follow these steps:
1. Slide the module up into its cradle.
2. Replace the front cover of the drive.
3. Apply power, set SP Enable Mask or set Fault Select 1.