Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 219)

Parameters 11-21
46 Droop Percent
Use Droop Percent to specify the percent of base speed that the
speed reference is reduced when at full load torque. You can use
this feature to cause motor speed to droop with an increase in
load.
Parameter number 46
File:group Control:Speed Regulator
Parameter type linkable destination
Display x.x%
Factory default 0.0%
Minimum value 0.0%
Maximum value 25.5%
Conversion 10 = 1.0
47
S-Curve Percent
1
Use S-Curve Percent to create an adjustable S curve ramp.
S-Curve Percent controls the level of filtering that is applied to the
output of the acceleration and deceleration ramp.
1 S-Curve Percent was added in Version 2.xx.
Parameter number 47
File:group Control:Accel/Decel
Parameter type linkable destination
Display x.x%
Factory default 0.0%
Minimum value 0.0%
Maximum value 100.0%
Conversion 10 = 1.0%
Refer to the Speed Reference Selection Overview in Appendix B,
Control Block Diagrams, for more information.
If S-Curve Percent is
set to:
Then the S-Curve is:
0 Not used.
50% Applied for half of the ramp time.
100% Applied for the entire ramp.
48 PTrim Output
PTrim Output represents the scaled and limited output of the
process trim function. You can use PTrim Output as a parameter
source or to offset the speed or torque reference. To offset the
speed or torque reference, you need to select either bit 0 or bit 1
in PTrim Select (parameter 51).
Parameter number 48
File:group Application:Process Trim
Parameter type source
Display ±x.x%
Factory default not applicable
Minimum value -800.0%
Maximum value +800.0%
Conversion 4096 = 100.0%
Refer to the Trim Control Overview section in Appendix B,
Control Block Diagrams, for more information.
49 PTrim Reference
PTrim Reference is the reference input value for process trim.
PTrim Reference and PTrim Feedback (parameter 50) are
compared and used to update PTrim Output (parameter 48).
Parameter number 49
File:group Application:Process Trim
Parameter type linkable destination
Display ±x.x%
Factory default +0.0%
Minimum value -800.0%
Maximum value +800.0%
Conversion 4096 = 100.0%
Refer to the Trim Control Overview section in Appendix B,
Control Block Diagrams, for more information.
50 PTrim Feedback
PTrim Feedback is the feedback input value for process trim.
PTrim Feedback and PTrim Reference (parameter 49) are
compared and used to update PTrim Output (parameter 48).
Parameter number 50
File:group Application:Process Trim
Parameter type linkable destination
Display ±x.x%
Factory default +0.0%
Minimum value -800.0%
Maximum value +800.0%
Conversion 4096 = 100.0%
Refer to the Trim Control Overview section in Appendix B,
Control Block Diagrams, for more information.