Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 99)

Chapter
6
Starting Up Your System
Chapter 6 provides information so that you can start up your system.
Chapter Objectives
Important: We recommend that you run the start up sequence to start
up your system most easily.
Before Applying Power to Your
Drive Before you apply voltage to your system, you should:
• Check the drive for any damage that may have occurred during
shipment and installation.
• Verify that all jumpers and configuration controls are properly set
for your application.
• Check all wiring external to the drive for accuracy and reliability.
• Verify that all external I/O wires are properly terminated in the
terminal blocks.
• Perform a full point-to-point continuity check on all I/O wiring
connected to the drive.
• Verify that the incoming power connections are properly
connected and tight.
• Verify that the power source is properly sized and protected for
your particular drive.
• Verify that the motor power connections are properly connected
and tight.
• Check the motor phasing. Motor phase A should be connected to
drive output phase A. Likewise, phase B and C should be
properly terminated to their respective terminals. This phasing is
double-checked during the start up procedure.
• For H frame drives, verify phasing of incoming power for correct
rotation of the 3 phase, top mounted fan.
• Verify that the Pulse Input Voltage Selection jumper is set
correctly for your application.
This Topic: Starts on Page:
Before applying power to your drive 6-1
Applying power to your drive 6-3
Recording your drive and motor information 6-3
Using the Human Interface Module (HIM) 6-4
Starting up your system 6-7
Running Quick Motor Tune 6-8
Running Digital Setup 6-10
Running Analog Setup 6-11
Understanding links 6-12
Where should I go from here? 6-14