Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX User Manual
Page 74
4-16
Mounting and Wiring Information Specific to Frames B, C, D, E, F, G, and H
Typical G Frame Mounting in User Supplied Enclosure
57.2
(2.25)
188.0
(7.40)
154.2
(6.07)
Length =
549.4 (21.63)
2 Plcs.
Each End
55.1
(2.17)
134.1
(5.28)
41.1
(1.62)
82.6 (3.25)
14.2 (0.56)
11.1 x 19.1
(0.44 x 0.75)
682.2 (26.86)
14.5 (0.57)
25.4 (1.00)
50.8 (2.00)
0.75 (19.1)
711.2 (28.00)
Bracket
This information represents the method used to factory mount an
open type Frame G in an enclosure specifically designed by
Allen-Bradley. Illustrations are only intended to identify structural
mounting points and hardware shapes. You must design and
fabricate steel components based on the actual mounting
configuration, calculated loads and enclosure specifications.
Minimum thickness of all parts = 4.6 (0.18).
Important:
Rail
Brace