Rockwell Automation 1336E IMPACT Adjustable Frequency AC Drive User Manual V 1-4.XX - Manual (Page 387)

Using the Human Interface Module (HIM) C-11
With a Series A (Version 3.0) or Series B HIM, you can program
Password mode to be displayed when drive power is applied. To do
this, you need to press the Increment and Decrement keys
simultaneously while the Password display is shown.
Once you set the password, the Program/EEProm modes and the
Control Logic/Clear Queue menus are password protected and are not
displayed in the menu. To access these modes, you need to:
1. Press any key from the status display. Choose Mode is shown.
2. Press INC or DEC to show Password.
3. Press ENTER.
4. Press ENTER. Enter Password is displayed.
5. Press INC or DEC until your correct password is displayed. With
a Series A (Version 3.0) or Series B HIM, SEL moves the cursor.
6. Press ENTER.
You can now access the Program and EEProm modes. To prevent
future access to program changes, you need to logout:
1. Press any key from the status display. Choose Mode is shown.
2. Press INC or DEC to show Password.
3. Press ENTER.
4. Press INC or DEC until Logout is displayed.
5. Press ENTER to log out of Password mode.
Creating a Link
You create links at the destination parameter. To create a link:
1. Go to the parameter that you want to receive the information.
2. Enter the number of the source parameter.
The following example uses a Human Interface Module (HIM) to
create a link. For this example, SP An Output (parameter 139) is the
destination parameter that is linked to Motor Torque %
(parameter 86), which is the source parameter. To create this link:
1. From the Choose Mode prompt, use INC or DEC to select Links.
2. Press INC or DEC to select Set Links. The HIM automatically
scrolls through the linear parameter list until it finds a parameter
that you can link.
3. Use INC or DEC to scroll through the parameter list until you
come to the destination parameter that you want to link. In this
example, you would use INC or DEC until you reach
parameter 139. The display should be similar to the following:
4. Press SEL. The display should now be similar to the following: