H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 218)

26-23
Figure 26-23 Add a DHCP server group
Type 1 for Server Group ID.
Type 10.1.1.1 for IP Address.
Click Apply.
# Enable the DHCP relay agent on VLAN-interface 1.
In the Interface Config field, click the icon of VLAN-interface 1. Perform the following
operations, as shown in Figure 26-24 .
Figure 26-24 Enable the DHCP relay agent on an interface and correlate it with a server group
Click on the Enable radio button next to DHCP Relay.
Select 1 for Server Group ID.
Click Apply.
Because the DHCP relay agent and server are on different subnets, you need to configure a static route
or dynamic routing protocol to make them reachable to each other.