H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 349)

33-13
For the configuration of authentication mode, see Wireless Service. Fast roaming supporting key
caching can be implemented only when RSN+802.1x authentication is adopted.
2) Configure a roaming group
Configure a roaming group on AC 1.
Select Roam > Roam Group from the navigation tree to enter the page for configuring a roaming group,
as shown in Figure 33-16 :
Figure 33-16 Configure a roaming group on AC 1
Select enable from the Service status drop-down list.
Select IPV4 from the Ip type drop-down list, and type 192.168.1.100 for Source address, namely,
the IP address of AC 1.
Type the IP address of AC 2 in the member list, click Add.
Click Apply.
Create a roaming group on AC 2. The source address is the IP address of AC 2, and the member
address is the IP address of AC 1.
Configuration verification
1) Verify the status of the roaming group.
On AC 1, you can see: