H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 597)

49-22
Figure 49-21 Network diagram for configuring traffic-mode load balancing
Configuration procedure
1) Before configuring load balancing, complete the following:
Configure AP 1 and AP 2 on the AC to establish a CAPWAP connection between the AC and each
AP. For the related configuration, see Wireless Service.
2) Configure traffic-mode load balancing
Select Advanced > Load Balance from the navigation tree to enter the page for setting load balancing,
as shown in Figure 49-22 .
Figure 49-22 Set traffic-mode load balancing
Select the Traffic mode.
Type the threshold 10, and the traffic gap 40.
Click Apply.
Configuration verification
Client 1 and Client 2 are associated with AP 1. Add Client 3 to the network. When the maximum traffic
threshold and traffic gap are reached on AP 1, Client 3 is associated with AP 2.