H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 286)

31-32
Figure 31-36 Enable wireless service
Select the service1 check box.
Click Enable.
3) Bind an AP radio to a wireless service
Select Wireless Service > Access Service from the navigation tree, and click Bind at the right side of
the wireless service service1 to enter the page for binding an AP radio, as shown in Figure 31-37 :
Figure 31-37 Bind an AP radio
Select the check box before ap with radio mode 802.11g.
Click Bind.
Select AP > AP Setup from the navigation tree to the see the AP is in IDLE state.
Figure 31-38 AP status before auto AP is enabled
4) Enable auto AP
Select AP > Auto AP from the navigation tree to enter the page for configuring auto AP, as shown in
Figure 31-39 :