Configuration verification, Configuration guidelines, Network requirements – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 596: N in, Figure 49-20
49-21
Figure 49-20 Set session-mode load balancing
Select the Session mode.
Type the threshold 5, and use the default value for the gap.
Click Apply.
Configuration verification
Client 1 is associated with AP 1, and Client 2 through Client 6 are associated with AP 2. Because the
number of clients associated with AP 1 reaches 5, and the session gap between AP 2 and AP 1 reaches
4, Client 7 is associated with AP 1.
Configuration guidelines
An AP starts session-mode load balancing only when both the maximum sessions and maximum
session gap are reached.
AP-Based Traffic-Mode Load Balancing Configuration Example
Network requirements
As shown in
, all APs operate in 802.11g mode. Client 1 and Client 2 are associated
with AP 1, and no client is associated with AP 2.
Configure traffic-mode load balancing on the AC. The traffic threshold is 3 Mbps that corresponds
to the threshold value of 10 in percentage, and the traffic gap is 12 Mbps that corresponds to the
traffic gap value 40 in percentage.