H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 328)

32-19
Then select the AP radio to be bound, and click the corresponding icon to enter the page for
configuring a peer MAC address, as shown in Figure 32-26 .
Figure 32-26 Configure a peer MAC address
Table 32-9 Configuration items for configuring a peer MAC address
Item Description
Peer MAC Address
The mesh feature supports three topologies. For details, refer to Mesh Network
Topologies . The mesh feature is implemented through configuration of peer
MAC addresses for each AP.
cos
Sets the STP cost of the mesh link to the peer. If not configured, the STP cost is
automatically calculated by STP.
You can view the cost of the mesh link on the page shown in Figure 32-26 .
Displaying the Mesh Link Status
Mesh Link Monitoring
Select Wireless Service > Mesh Service from the navigation tree, and click the Mesh Link Info tab to
enter the mesh link monitoring page, as shown in Figure 32-27 .
Figure 32-27 Display the mesh link monitoring information