IAI America MSCON - Manual (Page 78)

3.2 Initial Setting
70
[Step 13] Write the edited operation mode setting parameters to MSCON. Click on the “Transfer”
button shown below and a confirmation window pops up. Click on the “Yes” button.
If the writing is finished in normal condition, writing complete window appears. Click
OK.























[Step 14]
A confirmation window for Gateway Unit reboot opens. Click “Yes” to accept the reboot.








[Step 15]
After rebooting, a confirmation window for parameter reading appears for confirmation
of the written contents. Click “Yes” to accept the reading.
Once the reading process is complete, confirm that the written contents are reflected.
If not written properly, do the process again from Step 2.
 
Reference: The settings are conducted in the special parameters for the process
of communication error, change in pressing method for Fieldbus Type
and speed unit change for Direct Indication Mode. Refer to 3.9. About
Gateway Parameter Setting Tool for the details.