INFICON HAPSITE ER Chemical Identification System - Manual (Page 161)

4 - 1
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
Chapter 4
Wireless and Touch Screen Options
4.1 Wireless Option
4.1.1 Introduction
The HAPSITE has a wireless communication option, which can be used in place of
the cross-over cable for Laptop communication.
DANGER
The HAPSITE contains a wireless transmitter/receiver
that emits electromagnetic radiation (EMR). This
radiation in a tactical or operational environment may
potentially be used to locate the HAPSITE and its
operators. This radiation also has the potential to
detonate some types of unexploded ordnance (UXO), or
improvised explosive devices (IEDs), or both, if the
HAPSITE is transmitting in the safety exclusion area
around the device(s). There is a hardware switch to turn
off the wireless radio so that the HAPSITE may still be
used in areas where these hazards are a concern.
Consult applicable regulations and policies when using
the HAPSITE with the wireless device active in such
environments.
4.1.2 Regulatory Compliance Information for UNITED STATES Users
This section of the Operating Manual lists FCC compliance information for the
HAPSITE system that contains the wireless communication option.
NOTE: This equipment contains an OEM Embedded Wireless Bridge
(Ethernet to Wireless LAN) Module from Quatech Inc.
FCC ID: F4AWLNG1
This device compiles with Part15 of the FCC rules and is subject to the
following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference
that may cause undesired operation.