INFICON HAPSITE ER Chemical Identification System - Manual (Page 340)

11 - 2
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
 A Summary page is provided, at the end of the Method Editor, which allows for
review and printing of the Method parameters.
NOTE: Methods cannot be viewed, created or changed when Access Level is
set to Normal.
NOTE: In order to build a quantitative method, a Target Compound Library is
needed. See Chapter 12, Target Compound Methods for further
information.
Each functional page of the Method Editor shows a common profile at the bottom,
which depicts the Inlet States and Temperature Profile. Newly created Methods
start with a default set of Inlet States and a default Temperature Profile. These
can be changed as required by the application.
The Method Editor can be run in "Wizard" mode moves through the pages in a
logical sequence. It allows the user to make or review changes by using the Back
and Next keys. (see
Figure 11-1 ).
Figure 11-1 Method Editor Navigation Buttons
In "non-Wizard" mode, which is recommended only for experienced users, all
pages are available through a tab interface. To change the "Wizard" mode settings,
click System Properties >>Miscellaneous (see
Figure 11-2 ). The Method Editor
must be closed to change and affect this setting.
Figure 11-2 System Properties Miscellaneous Page Wizard Setting
All Method parameters, on each page of the Method Editor, are checked for
synchronization and correctness. The Method Editor automatically adjusts timing
of the Inlet and Acquisition components to force synchronization. Prior to making
automatic adjustments, the Method Editor colors the background of all
questionable parameters with yellow. Each Method Editor page also has an Error
Information button (see
Figure 11-3 ), which is colored yellow when parameters
are not synchronized. The Editor permits movement from page to page, even when
errors are present.
Figure 11-3 Error Information Button