INFICON HAPSITE ER Chemical Identification System - Manual (Page 203)

5 - 9
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
4 Click the desired method and then, click OK. This example shows the
ER_Air_Tri-Bed_PPB_Standard.mth method. See
Figure 5-12 .
Figure 5-12 Selecting the Method
5 The software will check the pressure in the gas canisters, heat up all necessary
components, run an AutoTune (if required), and make tune adjustments as
necessary. A Concentrator Cleanout will also be run if needed. The process
may take up to 20 minutes.
6 When it is done heating, a prompt will appear to indicate the HAPSITE is ready
to run a sample. Click RUN.
CAUTION
Do not place the sample probe in liquids while sampling.