INFICON HAPSITE ER Chemical Identification System - Manual (Page 54)

2 - 16
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
9 If using the HSS in portable mode, a battery will need to be installed. Open the
front door of the HSS and insert a charged battery into the rectangular slot
below the round carrier gas slot. Make sure when inserting the battery that the
lettering is right-side up to insure proper orientation. When inserted correctly, it
will click into place and remain snug. After battery has been properly installed,
disconnect the AC/DC power supply. See
Figure 2-15 . (For further instructions
on battery installation, refer to section 2.2.3 on page 2-9 .)
CAUTION
Do not open the HSS in a contaminated area. It is not
sealed against moisture, debris or contamination with
the front door open.
Figure 2-15 Inserting the Battery into the HSS