INFICON HAPSITE ER Chemical Identification System - Manual (Page 56)

2 - 18
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
The Service Module requires a power cable and a RS-232 communications cable
to allow communication with the Laptop.
Figure 2-18 shows the power cable
connected at the left back corner of the Service Module.
Figure 2-18 Power Cable Attached at Back Left of the Service Module with Power Switch Highlighted
The RS-232 communication cable is shown in Figure 2-19 .
Figure 2-19 RS-232 Communication Cable
To prepare the Service Module for use with the HAPSITE, the aluminum plug must
be removed. If the plug is not under vacuum, the plug can be easily detached. If
under vacuum, the plug will need to be removed using the following procedure:
NOTE: The Service Module is shipped under vacuum from the factory with this
plug in place.