INFICON HAPSITE ER Chemical Identification System - Manual (Page 273)

8 - 13
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
7 Select Use the following IP address and enter the IP address of the
HAPSITE, (refer to
Step 3 on page 8-22), with the number 128 added to the
third number of the first line of the IP address. This is necessary in order for the
system to configure communications properly. Example: 10.210.4.62 becomes
10.210.132.62. Press OK.
NOTE: If configuring the HAPSITE for a wireless configuration, change the
second number, 210, to 209.
Figure 8-16 Entering IP Address
8 Press OK in the Internet Protocol Window to close the window.
9 Communication between the HAPSITE and the Laptop is now established as
indicated by the HAPSITE Sensor in the ER IQ System Setup Window.
Figure 8-17 Active HAPSITE Sensor Icon