INFICON HAPSITE ER Chemical Identification System - Manual (Page 170)

4 - 10
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
4.1.8 Wireless Module Indicator Lights
Located on the Wireless Module inside the HAPSITE front cover are four indicator
lights.
RADIO . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the radio is enabled.
WLAN . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the wireless connection is
linked to the Laptop computer. The LED
blinks when transmitting or receiving data.
LAN . . . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the HAPSITE is
connected via a crossover cable to the
Laptop computer. The LED blinks when
transmitting or receiving data. The LED will
be extinguished if the crossover cable is
disconnected.
586 . . . . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the HAPSITE 586
processor is linked to a wired or wireless
connection.
4.1.9 Turning Off the Radio
If wireless communication is not desired, the radio on the HAPSITE ER can be
turned off. See the following procedure for direction on how to turn off the radio.
NOTE: When the HAPSITE radio is on, even if the wireless communication is not
being used, a radio signal is being transmitted. The only way to eliminate
the radio signal is to turn off the radio.
DANGER
The HAPSITE contains a wireless transmitter/receiver that
emits electromagnetic radiation (EMR). This radiation in a
tactical or operational environment may potentially be used to
locate the HAPSITE and its operators. This radiation also has
the potential to detonate some types of unexploded ordnance
(UXO), or improvised explosive devices (IEDs), or both, if the
HAPSITE is transmitting in the safety exclusion area around the
device(s). Discussed below is a hardware switch to turn off the
wireless radio so that the HAPSITE may still be used in areas
where these hazards are a concern. Consult applicable
regulations and policies when using the HAPSITE with the
wireless device active in such environments.