INFICON HAPSITE ER Chemical Identification System - Manual (Page 353)

11 - 15
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
Figure 11-12 Method Editor Inlet Page for GC/MS Full Scan
On the Inlet page, the only difference between an Analyze (GC/MS) Full Scan
method and an Analyze (GC/MS) SIM method is that the Run Time parameter entry
is replaced with a table showing the SIM Sets. SIM Sets are programmed on the
SIM page (refer to
section 11.3.2, SIM Method, on page 11-8 ). This difference is
shown in Figure 11-13 .
Figure 11-13 Inlet Page for Analyze (GC/MS) SIM