Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 106)

108 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 3 Configuring the Ultra3000 Drive
Understanding the
Oscilloscope Window The Properties window for the Oscilloscope looks like this
Use the Oscilloscope window to trace one of four drive signals by:
• Configuring the oscilloscope by selecting a the drive signal to trace.
• Executing commands that run the oscilloscope's tracing function
continuously or in response to the configured trigger.
• Monitoring the oscilloscope as it traces the selected drive signal.