Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 234)

236 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 5 Configuring the Kinetix 3 Drive
Using the Setup Wizard
The Kinetix 3 Setup Wizard helps you to perform the minimal configuration
necessary on a new Kinetix 3 drive.
Perform these steps to open and run the Setup Wizard.
1. In the Workspace window, click an online Kinetix 3 drive.
2. Do one of these steps to access the Setup Wizard.
• Click Setup Wizard in the Commands menu.
• Right-click Commands and Setup Wizard from the pop-up menus.
• Connect to an online Kinetix 3 drive to receive a prompt to run the
Setup Wizard.
The prompt can be disabled.
The Setup Wizard initially sets a small subset of the drive parameters. This
step makes sure that the other drive parameters are set to reasonable
defaults.
3. Click the type of Controller attached to your Kinetix 3 drive, or click
Other.
4. Click the Operation Mode for the Kinetix 3.
The wizard simplifies this decision by filtering the available operation
modes based on the drive controller that is connected to the Kinetix 3
drive.
5. Enter the operating parameters required for the selected operation mode.
6. Click your motor.
7. Tune the Kinetix 3 drive.
IMPORTANT As you step through the wizard, you modify parameters stored in
the drive. If you decide to cancel the wizard midway through
these steps, the Kinetix 3
drive will not return to the same state it
was before starting the wizard.
We recommend you perform a Reset to Factory Setting to the
Kinetix 3 drive anytime you cancel the Setup Wizard before
completing all of the steps.