Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 111)

Rockwell Automation Publication 2098-UM001G-EN-P - February 2011 113
Configuring the Ultra3000 Drive Chapter 3
The DeviceNet window has these parameters and statuses:
Parameter Description
Node Address Node address used for DeviceNet communication. This value is
used only if the rotary switch on the front panel is configured for
PGM.
Data Rate Data rate used for DeviceNet communication. This value is used
only if the rotary switch on the front panel is configured for
PGM. The options are:
• 125 kps
• 250 kps
• 500 kps
• Autobaud
I/O Receive Select Selects the output (consumed) assembly that is updated when a
polled, change of state, or cyclic I/O message is received by the
drive. The options are:
• No Data Consumed
• Assembly Instance 1
• Assembly Instance 2
• Assembly Instance 3
• Assembly Instance 4
• Assembly Instance 5
• Assembly Instance 6
• Assembly Instance 7
• Assembly Instance 8
• Assembly Instance 9
Note: Refer to the Ultra3000 DSD with DeviceNet Reference
Manual, publication 2098-RM001 for information on these
options.
Poll Transmit Select Selects the input (produced) assembly that is transmitted by the
drive over a polled I/O messaging connection. The options are:
• Assembly Instance 10
• Assembly Instance 11
• Assembly Instance 12
• Assembly Instance 13
• Assembly Instance 14
• Assembly Instance 15
• Assembly Instance 16
• Assembly Instance 17
• Assembly Instance 18
Note: Refer to the Ultra3000 DSD with DeviceNet Reference
Manual, publication 2098-RM001 for information on these
options.
COS/Cyclic Transmit Select Selects the input (produced) assembly that is transmitted by the
drive over a change of state or cyclic I/O messaging connection.
The options are:
• Assembly Instance 10
• Assembly Instance 13
• Assembly Instance 15
Note: Refer to the Ultra3000 DSD with DeviceNet Reference
Manual, publication 2098-RM001 for information on these
options.