Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 38)

40 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 3 Configuring the Ultra3000 Drive
3. To configure properties for the selected drive branch, use the features of
the Properties window as follows.
The remainder of this chapter describes the process of entering and editing drive
configuration settings, the status are displayed by default for each drive branch
when the drive is online, and the commands available to a user for each drive
branch when the drive is online.
Section Description
Parameters Located in the upper left part of the Properties window. Type or
click settings in the parameter fields to configure the drive branch.
Commands Located in the upper right part of the Properties window. Click any
button to issue the associated command. Click Show Commands,
below, to display command buttons. Not every drive branch has
associated commands.
Status Located beneath the Parameters and Commands sections. By
default, these fields display the online status of the selected drive
branch. Click Setup to open a window where you can customize the
status to be displayed. Status fields are read-only. Click Show
Status to display the status section.
Note: Status values for offline drives may not be meaningful.
Show Status Displays status for the drive branch.
Show Commands Displays commands for the drive branch. Commands can be
executed only for online drives. This selection is dimmed if no
commands are associated with the selected drive branch.
Setup Opens the Monitor Setup window, where you can customize the
status display.
Refer to Understanding the Monitor on page 105 for more
information about using the Monitor window.
Revert Returns parameter settings to the values they had when you first
opened this window.
Close Closes the window.
Help Displays online help for this window.